Omron K8DT-AS/AW 單相電流繼電器可檢測電動機和其他設備電流變化過程中的錯誤。
通過繼電器監測交流或直流電流。
與商用提供的電流變壓器一起使用
寬度為 17.5 mm，降低面板中所需的空間。
推入式接線端子可降低布線工作。
雙插入孔用于跨接布線（所有接線端子）。
K8DT-AS 可用于過電流或欠電流模式。
K8DT-AW 可同時監測過電流和欠電流
? Downsize control panels.
? Reduced wiring.
? Detects errors in Motors and other equipment via current changes.
? Use in either over current or under current mode.
? Function as an alarm.
? Set threshold values.
? Alarm output can be set as a relay or transistor output.
? Input signal – Voltage, current, water level electrode and temperature (thermocouple or platinum resistance thermometer) can be input.
? Lower power consumption.
? Long term contact reliability.
? Reliable in poor noise environments.
? Slim profile 17.5 mm
? Current Monitoring Relay.
? Single phase.
? Transistor Output.
? Power supply 24 V ac/dc.
? Setting range 2 to 20 mA ac/dc, 10 to 100 mA ac/dc, 50 to 500 mA ac/dc.
? Direct input.
? If using other current transformers Do Not exceed the overload capacity.
? Power supply 100 to 240 V ac, 50/60 Hz, 24 V dc
? Manual/ Automatic reset (switchable)
? Manual reset – Turn OFF the power supply for minimum of 1 sec.
? Start-up lock time 0 to 30 s.
? Green LED Power (PWR)
? Yellow LED output (OUT)
? Red LED Relay output (ALM)
? One SPDT contact relay, switchable normally closed (NC) and normally open (NO) using DIP switch.
? DIN Rail Mounted
? Weight 100 g
? Case material PC, UL 94 V-0.
? Colour N1.5
? Protection IP20 (terminals)
A monitoring / measuring relay is a protective control device, various types are available suiting what you wish to monitor. The relays receive input signals then monitor them and then output an alarm signal when a set value is reached (alarm relays). The relays protect your equipment against over voltage and over current faults. Monitoring relays monitor AC power supplies, voltage and current, analogue signals detecting unusual activity in equipment against set alarm thresholds.
? Motor protection relays
? Temperature monitoring relays
? Water level control relays
? Voltage
? Current
EN 60947-5-1, UL 60947-5-1, IP 20 Terminals
Omron K8DT 測試和監控繼電器是面板理念價值設計的一部分，該理念可控制面板設計，并使制造符合全新標準。 K8DT 系列可保護重要設備使用各種符合國際安全標準的測量和監控繼電器時免受傷害。 低功耗和低熱量設計可提供更長的工作壽命。
K8DT 系列通過降低布線管道和頂板空間之間的寬度，有助于縮小控制面板尺寸。 細長型主體使空間內可以安裝更多與控制面板同等大小的設備，從而增加控制面板的功能。
所有 K8DT 繼電器上的推入式接線端子塊可減少布線所需的時間和工作量。 推入式接線端子使得無需工具也可插入帶引腳接線端子的固態和絞合電線或套圈。
| 屬性 | 數值 |
|---|---|
| 監測應用 | 電流 |
| 觸點配置 | 單刀單擲 |
| 電氣相位 | 1 |
| 電流靈敏度 | 過載電流，低電流 |
| 最小電流感應 | 2 mA, 10 mA, 20mA |
| 最大電流感應 | 20 mA, 100 mA, 500mA |
| 延時 | 250ms |
| 安裝類型 | DIN 導軌 |
| 系列 | K8DT-AS |
